PHD 2-40 Pinhole/Holiday Detector
Buckleys Pinhole / Holiday Detectors enable inspectors to check quickly and effectively for porosity, pinholes and other faults in a wide range of non-conductive coatings and linings. The PHD 2-40 is suitable for checking coating thicknesses of between 60 microns to 26mm and is widely used in the petro-chemical, aerospace, pipeline construction and plastic fabrication industries.Special kits are available for testing pipeline coatings and bridge deck or roofing membranes.
COMPLETE KIT
comprises: PHD 2-40 unit with built-in charger and battery, shoulder bag, test probe handle with 2m high voltage lead, mains charger lead, earth lead (5m), steel drum brush, 150mm straight silicone rubber electrode, pointed probe, 2 x 460mm extension rods, earthing magnet, electrode shoe, trimming tool, test voltage calculator and comprehensive instruction manual, all contained in a robust carrying case.
FEATURES
- Clear LCD display of test voltage
- Audible and visual alarm fault indicators
- Calibration Certificate to National Standards supplied
- Power limited output for operator safety
- Safety Switch incorporated in handle
- Built-in Charger Unit
- Lightweight and portable
- Variable sensitivity for testing on concrete substrates or moist surfaces
- Full range of electrodes available
- One year “back-to-base” warranty
- CE approved
TECHNICAL SPECIFICATION
- Adjustable output voltage range: 2-40kV DC
- Variable sensitivity: 0-500uA
- Calibration Certificate to National Standards supplied
- Suitable for coating thicknesses 60 microns to 26mm
- Maximum continuous current: < 1mA
- Operating time: 7 hours average
- Meter accuracy: +/- 1%
- Mains voltage for charging: 110 to 230V AC 50/60 Hz
- Weight (unit only): 6.5Kg
- Dimensions (unit only): 21cm wide x 12.5cm high x 26.5cm deep
- Packed Weight (Complete kit): 11Kg
- Dimensions (packed): 62cm x 32cm x 25cm
Note: Due to ongoing technical developments, all stated information is typical and is subject to change without notice or obligation.
